87728-50 1600kg-Rated Trailer Coupling for 50×50mm Square Drawbars
4mm Pressed Steel Coupling Head with 90mm Mounting Centres for 50mm Tow Balls
| Item | Specification |
|---|---|
| Product Type | Square drawbar trailer ball coupling |
| Coupling Configuration | Unbraked |
| Stated Coupling Capacity | 1600kg |
| Compatible Drawbar | 50 × 50mm square tube |
| Compatible Tow Ball | 50mm |
| Body Material | Pressed steel |
| Specified Material Thickness | 4mm |
| Surface Finish | Zinc plated |
| Mounting Hole Centres | 90mm, centre to centre |
| Approval | E-Mark approved |
| Intended Use | Trailer towing connection |
Select the coupling within the approved limits of the complete trailer, towing vehicle, towbar and mounting arrangement.
The component’s capacity does not establish the permitted mass of an unbraked trailer.
Applications
Certificates
Q1. What drawbar size does this trailer coupling fit?
This version is designed for a 50 × 50mm square tube drawbar. Confirm the mounting dimensions and drawbar construction against the model-specific installation drawing before fitting.
Q2. What is the difference between the 50mm ball size and the 50×50mm drawbar size?
The 50mm ball size refers to the diameter of the towing vehicle’s tow ball. The 50 × 50mm dimension refers to the square tube drawbar on the trailer. Both interfaces must match the coupling specification.
Q3. What is the mounting hole spacing?
The specified mounting hole centres are 90mm. Measure from the centre of one mounting hole to the centre of the other, and verify the complete hole arrangement before selecting a replacement.
Q4. How thick is the coupling body?
The specified body material is 4mm pressed steel. Confirm the material specification against the exact model when approving samples or placing repeat orders.
Q5. Does the 1600kg rating allow an unbraked trailer to operate at 1600kg?
The 1600kg figure is the stated coupling capacity. It does not override the complete trailer’s approved mass, braking requirements, towing vehicle limits or applicable road regulations.
Q6. Is this a braked overrun coupling?
This version is specified for unbraked trailer configurations. It is not a complete overrun braking assembly. Select the coupling system according to the trailer’s approved braking configuration.
Q7. What approval information should an OEM buyer check?
Check the complete E-Mark approval number, approved model designation, characteristic load ratings and permitted mounting arrangement. These details should correspond to the supplied component and its approval documentation.
Q8. What should be checked before replacing an existing coupling?
Compare the tow ball size, drawbar profile, mounting hole centres, required load ratings and operating clearance. The 50mm tow ball fit alone does not establish that two coupling models are interchangeable.